Many people have asked about repairing their front covers/flaps on their Canon PowerShot SD series cameras, so I’ve written up some instructions. The barrier kit on most Canon PowerShot SD series cameras is a little tricky but not impossible to replace yourself. All you need is some patience, a steady hand and a small tipped screwdriver. We’ve been using dental picks for some time, they do a good job!

To start, you will need to turn on the camera and extend the lens, then open the battery door to turn off the camera and keep the lens out. This allows you to easily work on the lens barrier assembly.

First the part we need is the ‘barrel drive ring’, it’s the ring with the small piece that sticks down into the lens. Some cameras don’t have one, so if there isn’t one in your kit then your camera doesn’t need it. Be certain that it will rotate slightly after installation, otherwise it is probably not installed properly and can cause the lens to get jammed.

Next are the springs and flaps. There is a small little tab that holds the spring in place when you put it on the ‘flap’ or ‘barrier plate’ as they are actually called. They are TINY, they are hard to hold and if you drop it… please take my advice and don’t drop it, ok? We do have just the springs available for purchase, but please try not to lose them.

Gently put the flap in the hole with the spring laying towards the post that the free end will mount on; then with something with a very small tip (we use dental picks!) gently grab the loop of the spring and stick it on its post.

If you do this with the lens covers or ‘flaps’ in the open position they will stay in place once you get them properly seated. If everything pops off, just start again. Do not stretch out the springs as they must remain tight or nothing will work properly.

Then gently put on the barrier cover, it’s a flat plastic ring. There are tabs on the barrier cover, they match up with little slots on the lens and it locks into place. Be gentle, don’t force anything too hard or you will break it and the parts will not hold it place.

Now it’s time to test your skills! Put in the battery (cross your fingers) and press the power button! Is it working? Did it go flying across the room with a cute little *SPROING!* and maybe all the parts scattered all over the place? I hope not, but you’re not alone I’ve been there too.

Once you have it working smoothly …you’re almost done with your first digital camera repair!

Next put the dual sided tape on the barrier cover. CAUTION: Make sure to take the tape off of the backing paper but DON’T remove the paper that matches the shape of the tape on the other side!! If you take off the small paper part it will ruin the tape because it will fold and stick to itself. Bye bye tape!

The tabs fold over the edge, don’t let them stick out or the lens cover won’t fit and the lens will jam. The tape lines up with one tab at about the 11 o’clock position, then fold the tabs over and press them in so they don’t stick out.

Now put on your chrome or black lens cap, line up the cap with the small indentation at the bottom, you’ll see how it goes on easily.

Fire up the camera again and admire your handywork! Good for you! You now know how easy… and yet still hard digital camera repair can be, and the “Geek Squad” said that it was either unfixable or would be two hundred dollars and take several weeks to complete. Whatever Geek Squad… Whatever.

Hmm… I think I’m seeing the beginning of something big here; affordable do it yourself Canon camera repair!

Tagged with:

Filed under: Photography Articles